node-red-nodes/hardware/pigpiod/locales/en-US/pi-gpiod.json

{
    "pi-gpiod": {
        "label": {
            "gpiopin": "GPIO",
            "selectpin": "select pin",
            "host": "Host",
            "resistor": "Resistor?",
            "readinitial": "Read initial state of pin on deploy/restart?",
            "type": "Type",
            "initpin": "Initialise pin state?",
            "debounce": "Debounce",
            "limits": "Limits",
            "min": "min",
            "max": "max",
            "freq": "Frequency"
        },
        "place": {
            "host": "local or remote ip",
            "port": "port"
        },
        "resistor": {
            "none": "none",
            "pullup": "pullup",
            "pulldown": "pulldown"
        },
        "digout": "Digital output",
        "pwmout": "PWM output",
        "servo": "Servo output",
        "initpin0": "initial level of pin - low (0)",
        "initpin1": "initial level of pin - high (1)",
        "pinname": "Pin",
        "tip": {
            "pin": "<b>Pins in Use</b>: ",
            "in": "Only Digital Input is supported - input must be 0 or 1.",
            "dig": "Digital output - input must be 0 or 1.",
            "pwm": "PWM output - input must be between 0 to 100.",
            "ser": "Servo output - input must be between 0 to 100. 50 is centre.<br/>min. must be 500 us or more, max. must be 2500 us or less.",
            "dual": "Pins marked in blue are dual use. Make sure they are not enabled for their other use before using as GPIO."
        },
        "types": {
            "digout": "digital output",
            "input": "input",
            "pullup": "input with pull up",
            "pulldown": "input with pull down",
            "pwmout": "PWM output",
            "servo": "Servo output"
        },
        "status": {
            "stopped": "stopped",
            "closed": "closed",
            "not-running": "not running"
        },
        "errors": {
            "invalidpin": "Invalid GPIO pin",
            "invalidinput": "Invalid input",
            "error": "error: __error__"
        }
    }
}