1
0
mirror of https://github.com/node-red/node-red-nodes.git synced 2023-10-10 13:36:58 +02:00
node-red-nodes/hardware/PiFace/README.md

67 lines
1.9 KiB
Markdown
Raw Normal View History

node-red-node-piface
====================
<a href="http://nodered.org" target="_new">Node-RED</a> nodes to control a
<a href="http://www.piface.org.uk/products/piface_digital/" target="_new">PiFace Digital</a>
add-on board for a Raspberry-Pi.
**Note:** Some later versions of the PiFace relabelled the switch inputs to be `0 - 7`
instead of `1 - 8` as on the original boards.
We cannot automatically detect this so the user will have to apply some common sense.
Install
-------
2016-03-02 14:25:52 +01:00
Run the following command in your Node-RED user directory - typically `~/.node-red`
npm install node-red-node-piface
Pre-reqs
--------
Device Tree **must** be turned off. To do this run
sudo raspi-config
then select the `Advanced Options`, then `Device Tree`, and finally select `No`
and `OK`. You will then need to reboot.
It also requires the WiringPi gpio command to be installed in order to work.
See the <a href="http://wiringpi.com" target="new">WiringPi site</a>
for details on how to do this. The short version is...
sudo apt-get install git-core
git clone git://git.drogon.net/wiringPi
cd wiringPi
git pull origin
./build
Usage
-----
A pair of input and output Node-RED nodes for the Raspberry Pi PiFace Digital
add-on board.
### Output
The PiFace output node will set the selected relay, LED, or pin on or off
2016-03-02 14:25:52 +01:00
depending on the value passed in. Expects a `msg.payload` with either a
1 or 0 (or true or false).
Requires the WiringPi gpio command in order to work (see pre-reqs).
### Input
2016-03-02 14:25:52 +01:00
The PiFace input node generates a `msg.payload` with either a 0 or 1
depending on the state of the input pin.
You may also enable the input pullup resistor if required.
2016-03-02 14:25:52 +01:00
The `msg.topic` is set to <i>piface/{the pin number}</i>
Requires the WiringPi gpio command in order to work (see pre-reqs).
<b>Note:</b> This node currently polls the pin every 250mS. This is not ideal
as it loads the cpu.