node-red-node-arduino ===================== A Node-RED node to talk to an Arduino running standard firmata 2.2 or better. Install ------- Run the following command in your Node-RED user directory - typically `~/.node-red` npm i node-red-node-arduino Usage ----- The Firmata firmware must be loaded into the Arduino. See the [main documentation](http://nodered.org/docs/hardware/arduino.html) for details and examples of how to use this node. ### Input Node Connects to local Arduino and monitors the selected pin for changes. You can select either **Digital** or **Analogue** input type. Outputs the value read as `msg.payload` and the pin number as `msg.topic`. It only outputs on a change of value - fine for digital inputs, but you can get a lot of data from analogue pins which you must then handle. You can set the sample rate from `20` to `65535` mS. ### Output Node Connects to local Arduino and writes to the selected pin. You can select - **Digital** - accepts 0, 1, true, false, on, off - **Analogue** (PWM) - accepts Integer 0 to 255 - **Servo** - accepts Integer 0 - 180 Expects a numeric value in `msg.payload`. The pin number is set in the properties panel. *Note* - some servos will not travel a full 180 degree range so may only accept 30 - 150 degrees for example. Please use the `range` node to scale the input appropriately. ### Example Simple flow to blink Pin 13 [{"id":"d7663aaf.47194","type":"arduino-board","device":""},{"id":"dae8234f.2517e","type":"inject","name":"0.5s tick","topic":"","payload":"","payloadType":"date","repeat":"0.5","crontab":"","once":false,"x":150,"y":100,"z":"359a4b52.ca65b4","wires":[["56a6f8f2.a95908"]]},{"id":"2db61802.d249e8","type":"arduino out","name":"","pin":"13","state":"OUTPUT","arduino":"d7663aaf.47194","x":570.5,"y":100,"z":"359a4b52.ca65b4","wires":[]},{"id":"56a6f8f2.a95908","type":"function","name":"Toggle output on input","func":"\n// If it does exist make it the inverse of what it was or else initialise it to false\n// (context variables persist between calls to the function)\ncontext.level = !context.level || false;\n\n// set the payload to the level and return\nmsg.payload = context.level;\nreturn msg;","outputs":1,"noerr":0,"x":358,"y":100,"z":"359a4b52.ca65b4","wires":[["2db61802.d249e8"]]}]