diff --git a/FAQs.md b/FAQs.md
index f749435..41cbaf9 100644
--- a/FAQs.md
+++ b/FAQs.md
@@ -97,55 +97,7 @@ Follow these steps in the order below:
 Please note: Pi-hole integration is not officially supported by this project. Therefore, bug reports will not be addressed. 
 
 ### <a name="captive"></a>Can I configure RaspAP to work with a captive portal?
-Yes, the [nodogsplash project](https://github.com/nodogsplash/nodogsplash) works just fine with RaspAP and is recommended over other methods. No configuration changes are needed with raspap-webgui, however you will need to modify some default settings in the nodogsplash config. 
-
-The nodogsplash `GatewayInterface` should be set to the interface RaspAP runs on (`wlan0` is used by the Quick Installer). You will also need to change the `GateWayAddress` to `10.3.141.1`. 
-
-` sudo nano /etc/nodogsplash/nodogsplash.conf`
-
-```# Parameter: GatewayInterface
-# Default: NONE
-#
-# GatewayInterface is not autodetected, has no default, and must be set here.
-# Set GatewayInterface to the interface on your router
-# that is to be managed by Nodogsplash.
-# Typically br-lan for the wired and wireless lan.
-#
-GatewayInterface wlan0
-```
-
-```
-# Parameter: GatewayAddress
-# Default: Discovered from GatewayInterface
-#
-# This should be autodetected on an OpenWRT system, but if not:
-# Set GatewayAddress to the IP address of the router on
-# the GatewayInterface.  This is the address that the Nodogsplash
-# server listens on.
-#
-GatewayAddress 10.3.141.1
-```
-
-Give the nodogsplash service a kick:
-
-`sudo systemctl restart nodogsplash`
-
-and verify that the service is running:
-
-`sudo systemctl status nodogsplash`
-
-```● nodogsplash.service - NoDogSplash Captive Portal
-   Loaded: loaded (/lib/systemd/system/nodogsplash.service; enabled; vendor preset: enabled)
-   Active: active (running) since Sat 2019-03-02 07:55:11 UTC; 11min ago
-  Process: 3404 ExecStart=/usr/bin/nodogsplash -d 5 $OPTIONS (code=exited, status=0/SUCCESS)
- Main PID: 3405 (nodogsplash)
-   CGroup: /system.slice/nodogsplash.service
-           └─3405 /usr/bin/nodogsplash -d 5
-```
-
-Point your browser to http://10.3.141.1 and you should see the default nodogsplash page. 
-
-![image](https://i.imgur.com/arTZmii.jpg)
+Yes, the [nodogsplash project](https://github.com/nodogsplash/nodogsplash) works just fine with RaspAP and is recommended over other methods. A detailed setup guide is [available here](https://github.com/billz/raspap-webgui/wiki/Captive-portal-setup). 
 
 ### <a name="wireless-mode"></a>Why can't I access wireless mode 'N' (802.11n)?
 On the **Configure hotspot** > **Security** tab, be sure to select CCMP for the Encryption Type. Save the settings and restart the hotspot. The wireless mode should be reported on clients as 802.11b/g/n.