mirror of
https://github.com/node-red/node-red-nodes.git
synced 2023-10-10 13:36:58 +02:00
70 lines
2.0 KiB
Markdown
70 lines
2.0 KiB
Markdown
node-red-node-intel-gpio
|
|
========================
|
|
|
|
A <a href="http://nodered.org" target="_new">Node-RED</a> node to talk to an Intel
|
|
Galileo or Edison running mraa.
|
|
|
|
Install
|
|
-------
|
|
|
|
Run the following command in your Node-RED user directory - typically `~/.node-red`
|
|
|
|
npm i node-red-node-intel-gpio
|
|
|
|
Usage
|
|
-----
|
|
|
|
The Galileo or Edison must already be running Linux, and have Node-RED installed.
|
|
|
|
See the [Intel Downloads](https://software.intel.com/en-us/iot/home) for
|
|
hardware / downloads for your particular board.
|
|
|
|
Ensure the latest version of mraa libraries are installed: (version 1.5 as of Sept 2015)
|
|
|
|
echo "src mraa-upm http://iotdk.intel.com/repos/1.5/intelgalactic" > /etc/opkg/mraa-upm.conf
|
|
opkg update
|
|
opkg upgrade
|
|
|
|
**NOTE** : This node assumes that the mraa npm is already installed globally - as
|
|
it is on the Galileo and Edison boards.
|
|
|
|
If you do need to install Node-RED, you can do this as follows from the home directory of the root user
|
|
|
|
npm install -g --unsafe-perm node-red
|
|
mkdir .node-red
|
|
cd .node-red
|
|
npm install node-red-node-intel-gpio
|
|
|
|
### Analogue Input Node
|
|
|
|
Monitors the selected pin for changes. It outputs on a change of value.
|
|
As analogue inputs are continuously changing you can set the sample rate in ms from 20 to 65535.
|
|
|
|
### Digital Input Node
|
|
|
|
Monitors the selected pin for changes. It only outputs on a change of value.
|
|
|
|
### Digital Output Node
|
|
|
|
Sets the selected digital pin output high or low depending on the value of
|
|
`msg.payload` - expects a number or string 0 or 1.
|
|
|
|
### Pulse Width Modulation (PWM) Node
|
|
|
|
The `msg.payload` should contain a floating point number value
|
|
between 0 (off) and 1 (fully on), or a string representation thereof.
|
|
|
|
You can set the overall period (mS) in the edit dialogue.
|
|
|
|
For servo control set the period to 20mS and vary the input between 0.05 and 0.10,
|
|
|
|
0.05 = 5% of 20mS = 1mS
|
|
0.75 = 7.5% of 20mS = 1.5mS - typical servo centre point
|
|
0.10 = 10% of 20mS = 2mS
|
|
|
|
### Example
|
|
|
|
Simple flow to blink Pin 13
|
|
|
|
...tbd
|