- The EIT information is now gathered in a separate thread.
- The sytem time can now be synchronized to the time broadcast in the DVB data
stream. This can be enabled in the "Setup" menu by setting "SetSystemTime" to
1. Note that this works only if VDR is running under a user id that has
permisson to set the system time.
- The new item "Schedule" in the "Main" menu opens VDR's EPG (thanks to Robert
Schneider). See the MANUAL file for a detailed description.
- The new setup parameters MarginStart and MarginStop define how long (in
minutes) before the official start time of a broadcast VDR shall begin
recording, and how long after the official end time it shall stop recording.
These are used when a recording is programmed from the "Schedules" menu.
- The delay value in the dvb.c.071.diff patch to the driver has been increased
to '3', because on some systems the OSD was not displayed correctly. If you
are running an already patched version 0.71 driver and encounter problems
with the OSD, please make sure the parameter in the ddelay call is '3', not
'2'.
- Fixed initializing the RCU remote control code (didn't work after switching
on the system).
- Problematic characters in recording names (which can come from timers that
are programmed via the "Schedules" menu) are now replaced by suitable
substitutes.
- The Makefile now defines DVBDIR to easily point to where the DVB driver
source is located.
- When switching channels the current/next information is now displayed if
available (thanks to Robert Schneider). Since there is now more information
to read when switching channels, the timeout for displaying it has been
increased from 2 to 5 seconds (remember that this info can always be recalled
by pressing the "Ok" button).
For this feature to work it is necessary that the 'Pnr' parameter in the
channel setup ('channels.conf') is set to the proper value. This has been
done for some of the channels in the default 'channels.conf'. Some other
parameters in the default 'channels.conf' have also been updated, so please
make sure your timers still use the correct channels!
